PRODUCTS

INSTALLATION INSTRUCTIONS

INSTALLATION STEP FOR SPIN-ON TYPE OIL FILTERS


When installing the oil filter:


1. Lubricate filter rubber gasket with engine oil.

2. Hand tighten until the gasket contact the seat of filter mounting give it additional 3/4 turn to seat the filter.

3. After adding the oil,run engine for 3 minutes and check for leakage of oil.


INSTALLATION STEP FOR ELEMENT TYPE OIL FILTERS


When installing the oil filter:

1. Remove the filter housing from the mounting and then remove the element from the filter housing.

2. Clean the mounting and filter housing

3. Always use new O-rings when replacing the element. Be sure not to damage the O-rings when installing.

4. Installing the new element into the filter housing and installing the filter housing to the mounting. Refer to the instruction on the manual.

5.Start the engine and check for leakage of oil.


IMPORTANT

1. Improperly installed oil filter can result in engine damage.

2. Refer to owner's manual for proper oil filter change interval.

3. Should be kept in normal temperature and not exposed to moisture.





Connect with NN1


Shop And Learn